UV seams are interfering with simplification.

[ZagolskiG]

Hello!
If the mesh has a lot of seams, the simplification is bad. As far as I understand, the seam vertices are always locked? Is it possible to implement a more flexible setting that would allow adjusting the seam quality / simplification amount? This would be very much in demand.

[zeux]

The seams are not fully locked - the simplification is constrained to only simplify along the seams. This is important to actually preserve the discontinuities. You are correct in that if the mesh has lots of seams, this limits the simplification significantly.

[ZagolskiG]

Anyway, I would like to thank you for the useful program! And thank you for continuing to improve it.