Shelly 1PM Gen3

[FerFemNemBem]

Hi,

I've bought a new device "Shelly 1PM Gen3" ( https://kb.shelly.cloud/knowledge-base/shelly-1pm-gen3 ).
It has an "ESP-Shelly C38F/0924" Chip.
Is this something that is compatible with an ESP32?
Any chance to flash Tasmota (Serial or OTA)?

Cheers,
FFNB

[Jason2866]

Flash (via serial) by using the Tasmota WebInstaller. This will only work when the orig. Shelly firmware has no Matter support

[FerFemNemBem]

Hi @Jason2866 ,

sounds good!
The image to use in the WebInstaller would be the (unofficial) "Tasmota32-C3 2M" - right?

Did you already have a template for the Shelly 1PM Gen3?
If not, can I start with the Template from Theo Arends;
{"NAME":"Shelly 2PM Gen3","GPIO":[9472,3458,576,225,4736,224,640,608,1,1,193,0,0,0,0,0,0,0,192,32,1,1],"FLAG":0,"BASE":1}
mentioned in this post: #22526 and remove the second channel?

Thanks,
FFNB

[sfromis]

No, do not use the reduced 2M build, unless you have crappy hardware. Just let the web installer select automatically.

[arendst]

Find the correct template in the changelog.

{"NAME":"Shelly 1PM Gen3","GPIO":[0,32,0,4736,224,0,3200,8161,576,1,192,0,0,0,0,0,0,0,0,1,1,1],"FLAG":0,"BASE":1,"CMND":"AdcGpio3 10000,10000,4000"}

[FerFemNemBem]

Thank you all @Jason2866 , @sfromis and @arendst .
I will test!

[FerFemNemBem]

Works like a charm with the instructions given above!

Thanks again!

[Noschvie]

Connected a Plus Add-On to the Shelly 1PM Gen3 ... looks like it works :-) Thanks!